Addendum A
A-1
Matrix Refresh Report Enable
Addendum A
Addendum A
RCP1 Protocol for UDS
This addendum contains additional detail associated with serial interfacing; describing the
basic commands supported for serial-to-router communications.
Matrix Refresh Report Enable
ASCII CODE HEX
Command Code: ESC @ 1B, 40
Response: None
The ESC @ sequence causes the System Controller to routinely report crosspoint
information to the external computer.
Refresh data is provided on an unsolicited basis with the data format as follows:
STX OOOO <Matrix Input> <Matrix Output> <Checksum> CR
Related Commands:
MATRIX REFRESH REPORT DISABLE
Matrix Refresh Report Disable
ASCII CODE HEX
Command Code: ESC A 1B, 41
Response: None
Matrix Refresh reporting is described in the previous section. To disable the function, the
Matrix Refresh Report
Disable Command
is provided.
Issuing the command string ESC A will disable Matrix Refresh Reporting.
Related Commands:
MATRIX REFRESH REPORT ENABLE
Содержание UTAH-100 UDS-288
