12
Helike 1.0 UA-E3010 | User manual
Released in November 2020, updated in June 2022
USound GmbH | www.usound.com | [email protected]
S1-1
S1-2
S1-3
S1-4
SD configuration file
USound Device
Off
Off
Off
Off
N.A
Passthrough (default)
Off
Off
Off
On
config-1.bin
Dione Mini UY-R3010
Off
Off
On
Off
config-2.bin
Dione Maxi UY-R3020
Off
Off
On
On
config-3.bin
Danube 5.0
UAM-R2050
Off
On
Off
Off
config-4.bin
Carme kit UJ-E1040G00 speaker
box/Carme 3.0 UJ-R1030 equipped with
Adap speaker
Off
On
Off
On
config-5.bin
Carme kit UJ-E1040G00 speaker
box/Carme 3.0 UJ-R1030 equipped with
Achelous speaker
1)
Off
On
On
Off
config-6.bin
Available for user/custom configuration
Off
On
On
On
config-7.bin
Available for user/custom configuration
On
Off
Off
Off
config-8.bin
Available for user/custom configuration
On
Off
Off
On
config-9.bin
Available for user/custom configuration
On
Off
On
Off
config-10.bin
Available for user/custom configuration
On
Off
On
On
config-11.bin
Available for user/custom configuration
On
On
Off
Off
config-12.bin
Available for user/custom configuration
On
On
Off
On
config-13.bin
Available for user/custom configuration
On
On
On
Off
config-14.bin
Available for user/custom configuration
On
On
On
On
config-15.bin
Available for user/custom configuration
Table 6: DIP switch position for filter selection
1)
Formerly this configuration slot was used for Sentia. Sentia is no longer supported.
7.1.
CARME SPEAKER BOXES
Carme kit UJ-E1040G00 speaker boxes and Carme 3.0 UJ-R1030 speaker boxes can be fitted with a single
MEMS speaker (Adap or Achelous). Both can be connected to Helike 1.0 UA-E3010 in the same way as
described below. A total of four Carme speaker boxes can be attached to the Helike 1.0 UA-E3010 PCB via
Jumpers J12, J19, J14, and J20 (2x left, 2x right).
7.1.1.
DIP SWITCH SETTINGS
To select the correct filter configuration for the Carme speaker being used, set the DIP switches S1-1
through S1-4, as shown in Table 6. This ensures that the correct filter coefficients are loaded into the audio
pipeline.
