usi 1800-2700, Руководство пользователя

Страница: 11 / 34

11
TYPE HEAT RANGE
Standard 260-290°F
Opti Clear 210-245°F
Photo Plus 220-250°F
DigiSeal 180-220°F
Photo 11-1
HEAT SETTINGS
Turn the heat on by depressing the main heat power switch on the left side panel. The red indicator light will illuminate
and remain lit while the heat switch is in the on position.
The display board on the right side panel will now illuminate and show the current set temperature. To set the tem-
perature, rotate the control knob located below the display
(Photo 11-2). The new temperature will be displayed immediately. The heat indicator lamp
will be illuminated while the machine is heating, and will turn off when set temperature is reached. To see the lamina-
tor’s actual running temperature, depress the ACT button on
the display board.
Prior to laminating, allow the machine to pre-heat at least 15 minutes in order to stabilize the
temperature. Temperature settings depend on the film type being used. The temperature is preset at the factory, but
may require adjustment depending on what type of film you are using.
Note: When setting the heat to a temperature below 200°F, first rotate the heat control knob fully clockwise and then
proceed to set to desired temperature.
The display can easily be toggled between Fahrenheit and Centigrade by depressing the
C/F button.
Photo 11-2