usha FH 1212 PTC, Инструкция по эксплуатации

Страница: 6 / 12

6
sAFETy coNTRol (THERMAl cuT-ouT):
CAUTION - This product has two overheat protection devices. The first
protection device is an overheat switch which can be re-set, once the cause
of the overheating has been removed AND the heater has cooled down.
The product can then continue to be used normally. The second overheat
protection device is a thermal fuse which CANNOT be reset by the user.
In the event that the heater stops working as a result of overheating take the
following immediate steps: switch the electricity off at the socket and remove
the plug. Remove any objects that are covering the product. CAUTION:
Do not touch the heater as it will be hot. Set the heater switches to OFF
and leave the heater to cool down fully. Once completely cool, reconnect
the heater and switch it on. If it fails to work it is likely that the secondary
overheat protection device (thermal fuse) has operated – this overheat
protection system cannot be reset by the consumer.
Do not open this product. There are no user-serviceable parts inside.
TEcHNIcAl spEcIFIcATIoNs
• Model: FH 1212 PTC
• Voltage: 220-240V AC, 50Hz
• Wattage: Low: 900W/ High: 1500W
MAINTENANcE ANd clEANINg
1. Switch off and unplug from the power supply before cleaning.
2. Using a soft, moist cloth, with or without a mild soap solution, carefully
clean the exterior surface of the product.
CAUTION: Allow the product to completely cool before handling or
cleaning it.
3. Do not allow water or other liquids to run into the interior of the product,
as this could create a fire and/or electrical hazard.