usha CH 3408, Инструкция по эксплуатации

Страница: 6 / 8

6
• Turn the power switch to Horizontal mode, then turn the timer to the required
time setting within 180 minutes, for desired heating time.
• After use, turn off the switch and pull out the power cord.
• Allow the unit to cool down before storage.
Warning: When changing between the 2 positions, make sure to turn the power
switch to “0” position before changing.
SAFETY DEVICE
This appliance is fitted with safety cut-off device that disconnects the appliance when
the appliance is not in the right position. Always ensure that the unit is placed on a
flat solid ground before operating.
TIMER
A 3 hour timer is built into the control panel, to set the desired time just turn the knob
within 0 to 180 minutes range, for unlimited heating, turn the timer control to “on”
position.
CARE AND CLEANING
• Before cleaning, ensure that the heater is switced off and is unplugged from the
socket, allow it to cool thoroughly .
• Clean the exterior surface of the heater with a dry, soft cloth.
• Never use any form of detergent or solvents to clean the heater.
• Never spray with liquids or submerge in liquids or water.
• DO NOT attempt to clean the interior of the heater.
• DO NOT ATTEMPT TO OPEN THE CASE OF THIS HEATER at any time.
There are no consumer serviceable parts inside the unit.
• When the heater is stored during off season, neatly wind the cord around the
base of the heater to prevent any damage to the cord.
Note: In case of any defect do not tamper with the appliance yourself. Contact Usha
Care.