CLEANING & MAINTENANCE
WATER DRAIN PLUG
OPEN SCREWS
DRAINING AND CLEANING THE WATER TANK
• Turn the power “off” and disconnect the air cooler from the power supply.
• Move the unit to a location where it can be drained. Remove the cap from the
water drain plug and allow the tank to empty (see parts description on page 9).
• After you have drained the water tank, please connect the water drain plug to its
original position.
• Now refill the water tank up to Max level, wait for 5 min. and then drain the entire
water once again. Use clean water for this procedure, so that maximum dust
particles and remains are completely removed.
• If your cooler has not been used for a long duration, we advise you to clean the
water tank at least 2 times before it is used again.
CLEANING THE HONEYCOMB MEDIA
• Turn off the unit, and unplug the power cord from wall outlet Rotate the unit
facing the back panel, and locate the Rear Grill
• Removal Screws (refer page 9., #12). Remove the screws with a screw driver.
• Pull the rear grill panel upwards, until it is completely removed. Now, the
honeycomb media can be seen. Clean the honeycomb media with fresh water.
• Once the cleaning has been completed, assemble the unit as described above.
• Plug into the power supply and turn unit on.
17
16
CLEANING & MAINTENANCE
IMPORTANT
• The cooler is supplied with Honeycomb Cooling Media.
• The cleaning frequency for the Honeycomb media depends on local air and
water conditions. In areas where the mineral content of water is high, mineral
deposits may build up on the Honeycomb Cooling Media and restrict air flow.
Draining the water reservoir and refilling with fresh water at least once a week
will help reduce mineral deposits. If mineral deposits remain on the Honeycomb
media, the media should be removed and washed under fresh water. The media
should be cleaned every two months or sooner, depending on your needs.
Do not run the unit in COOL mode with stale water in the tank. Empty the tank
and refill it with fresh water if the water has been standing in the tank for an
extended period of time.
• For best results, allow the Honeycomb Cooling Media to dry after each use by
turning off the cool function 15 minutes before turning the unit off.
• Draining the water reservoir and refilling with fresh water at least once a week
will greatly reduce mineral deposits in the pads and help to extend the life of
Honeycomb Cooling Media.
WARNING
• Before cleaning the unit, switch it to the “off’’ position and remove the plug from
the power socket.
• To clean the outside, use a damp cloth to remove dirt and dust.
• Never use corrosive elements or any chemicals to clean this product.
• When the product is not in use, store the unit in a dry place out of direct sunlight.
• Maximum water inlet pressure 0.5MPa
Содержание AIR KING
Страница 12: ......
