Installation
05/20
Fl Detect RF Set
9
5
Installation
5.1
Placement of the radio water detectors
Place the water detectors on the floor so that in the event
of an alarm, the three contact surfaces of the detectors
can come into contact with water.
5.2
Placement of splitter and cables
Install the splitter and all I/O cables higher than the water
sensor to protect the splitter and connectors from water
in case of flooding.
5.3
Electrical connection
Insert the I/O connector of the wireless water detector (1) into
the Fl I/O connector.
If the connector is already in use, please use the splitter and the
I/O cable.
When the I/O connector is plugged into the socket, this
must cause a clicking noise. If not, please check again
that the connector is properly engaged!
When disconnecting connections, please make sure to
press the locking lugs of the I/O connectors!
