USC SEED 16 Series, Руководство оператора

Страница: 24 / 124

Page 24
Seed Series 16 & 20 Conveyor
Efficient and safe operation of the Seed Series Conveyor requires that each operator
reads and understands the operating procedures and all related safety
precautions outlined in this section. A pre-operation checklist is provided for the
operator. It is important for both the personal safety and maintaining the good
mechanical condition of the Conveyor that this checklist is followed.
Before operating the Conveyor and each time thereafter, the following areas should
be checked off:
1. Service the machine per the schedule outlined in Section F, Maintenance.
(Page 32)
2. Use only an electric motor of adequate power to operate the machine.
3. Check that all guards are installed, secured and functioning as intended. Do not
operate with missing or damaged shields.
4. Check worksite. Clean up working area to prevent slipping or tripping.
5. Check winch and cable for security and operation. There should be at least 3
complete wraps of cable around winch drum in full down position. Cable anchor
on winch drum must be tight. Inspect cable for fraying or damage and replace if
damaged or frayed.
6. Check that cable clamps are secure.
7. Check that drive belt and conveying belt are not frayed or damaged and that they
are properly adjusted and aligned.
8. Be sure Conveyor wheels are chocked.
9. Check that discharge and intake areas are free of obstructions.
Anchoring and / or support of Conveyor during operation is
necessary. When the lower half of Conveyor empties of material,
the weight balance transfers to the upper end of the machine,
which can cause upending.
PRE-OPERATION CHECKLIST