DiscountCarStereo.com
CHANGING SOURCE TO AM/FM/CD/CASSETTE
when a source other than the iPod (i.e. Radio, Cassette etc) is selected on the radio, the iPod will
pause.
7. INSTALLATION WITHOUT XM
Remove the radio [a VW radio removal tool (not included) may be required].
Disconnect existing CD Changer from the radio if there is one
Plug the round DIN plug on CAS-VW6 to PA11-VW6 adapter where it is labeled “RADIO”
Plug the white (12-pin) or blue (8-pin) connector on CAS-VW6 to radio’s CD Changer connector.
(if a cd changer exists, disconnect it first)
Connect the black color ground wire on CAS-VW6 cable to radio’s metal chassis. (don’t ignore
this step)
Connect the audio output of the auxiliary device to AUX input jack on PA11-VW if the additional
AUX option is selected by setting DIP switch #1 to “OFF” (optional)
Set DIP switch #2 to “OFF” only if “DIRECT MODE” is preferred.
Plug CB-PA14 cable to PA11-VW6 adapter box labeled “iPod”
Reinstall the radio.
8. INSTALLATION for vehicles equipped with XM
To retain your factory SAT radio three wires on factory SAT connector need to be moved to the white
connector 12-pin connector supplied with the PA11-VW6 harness. Please follow below to accomplish
the installation.
Unplug the 12-pin blue factory SAT connector at the back of the radio
Reference the drawing below to disassemble the connector. Pushing the inner piece of the
connector with a small tool through the open hole at the side of the connector. See fig below.
Push the horizontal bar on the other side of the connector upward to release the latch. The
inner piece of the connector will slide out.
Reference the drawing below, pull out the wire at pin#1 on the factory SAT connector with a
tool. Reference the drawing below, raise the key on the pin and insert it into pin #1 of white
connector on USASPec harness.
Reference the drawing below, pull out the wire at pin #3 on factory SAT connector with a tool.
Reference the drawing below, raise the key on the pin and insert it into pin #3 of white
connector on USASpec harness.
Reference the drawing below, pull out the wire at pin #7 on factory SAT connector with a tool.
Reference the drawing below, raise the key on the pin and insert it into pin #7 of white
connector on USASpec harness.
Assemble the white connector on USASpec harness by pushing the inner piece into the outer
piece.
Plug the white connector on USASpec harness into the radio.
WARNING!!
Use only the iPod connection cable (part no. CB-PA14) included with the PA11-VW6 interface. IPod
connection cables from other sources may look similar, but using them may damage your iPod
