Note: On some of HONDA radios, the 14-pin connector is located
on the bottom side of the radio chassis.
Section 4. CABLE CONNECTION
in Section 3.
If a factory cable with the same identical 14-pin male connector is already
connected to the radio then unplug the factory cable from the radio first.
on CAS-H2Y cable. Reference Fig. (1).
adaptor where it is labeled RADIO.
with a relay. Reference Fig. (3).
Step 1-Decide which MODE to use and set DIP switches according to information
Step 2-Must remove or eject all CDs from the radio.
Step 3-Remove the radio from dash.
Step 4-Plug the 14-pin male connector on the
USA_SPEC
CAS-H2y cable to the radio.
Step 6-Plug the factory 14-pin male connector to
USA_SPEC
14-pin female connector
Step 7-Plug the round 8-pin DIN connector on the
USA_SPEC
CAS-H2y cable to the
Step 8-If the vehicle has Rear-Seat-Entertainment system, wire ACCessory power
is selected by DIP switch #1=ON.
Step 9- Connect your audio source to the RCA jacks on the adaptor if AUX option
Step 14- Plug the orange color wire on CAS-HXM to PA15-HON2 adaptor where
Step 15- Go to Step 7, 8, 9, 10 and 11.
it is labeled XM.
14-pin female connector on the
USA_SPEC
CAS-H2y cable.
Step 13- Plug the 14-pin male connector on the
USA_SPEC
CAS-HXM cable to the
CAS-HXM cable. Reference Fig. (2) .
Step 12- Plug the factory 14-pin cable to the 14-pin female connector on the
USA_SPEC
Step 11- Reinstall radio back to the dash only after a successful test is done.
Step 10- Plug the CB-PA105 cable to the adaptor where it is labeled iPod.
Step 5-If DIP switch #2 is set to OFF position and the vehicle has a factory XM
receiver, skip to step 12.
10