TECH. SUPPORT
( 6 2 6 ) 3 3 6 - 3 8 3 6
9 AM ~ 4 PM PST
M O N ~ F R I
Instruction of Cable Installation for VW Equipped with SAT
1 2 3 4
TO RADIO
CONNECT
TO RADIO
FRONT VIEW
4-POSITION DIP SWITCH
ON: when switch is at
bottom position
TO iPod
REAR VIEW
CB-PA14
AUX input
Blue
connector
SAT
Step 1:
Unplug factory SAT
connector from the
back of car radios.
Step 4/5/6: Pull out wires at pin #1,#3,#7
and insert into pin #1,#3,#7 of black inner piece
of white connector at CAS-VW6.
Back of car radio
Step 8: Plug CAS-VW6 to
the back of car radio again
Step 2/3:
Connector disassemble illustration.
To pull out wires at pin #1, #3, #7:
pull the wire tight while press
the key by using a pinset as shown.
To insert the wires into pin #1, #3, #7:
raise the key up as shown,
then insert into the pin hole
Back of car radio
To retain your SAT reception, three wires on factory SAT connector need to be moved to the white connector on cable.
Please follow the steps below to accomplish the installation.
Step 1. Unplug the 12-pin blue color factory SAT connector at the back of the radio.
Step 2. Reference the drawing below to disassemble the connectors. Pushing the inner piece of the connector with a small tool
through the open hole at the side of connector. At meantime, push the horizontal bar on the other side of connector upward
to release the latch. The inner piece of the connector will slid out.
Step 3. Referrnce the drawing below, pull out the wire at pin #1 on factory SAT connector with a tool.
Reference the drawing below, raise the key on the pin and insert it into pin #1 of white connector on connector.
Step 4. Referrnce the drawing below, pull out the wire at pin #3 on factory SAT connector with a tool.
Reference the drawing below, raise the key on the pin and insert it into pin #3 of white connector on connector.
Step 5. Referrnce the drawing below, pull out the wire at pin #7 on factory SAT connector with a tool.
Reference the drawing below, raise the key on the pin and insert it into pin #7 of white connector on connector.
Step 6. Pull out the wire at pin #7 of factory SAT connector and insert it into pin #7 of white connector on cable.
Step 7. Assemble the white connector on cable by push the inner piece into the outer piece.
Step 8. Plug the white connector on cable CAS-VW6 to the back of radio again.
