13
FINAL STEP & NOTES
ARRAIGNMENTS:
Remember you can arrange your floor to form a square, rectangle, or runway. Pictured below are only a
few ideas.
FINISHING STEP:
Once all the Floor Panels are connected
and the screws have been “Started”,
it is time to secure all of
the screws and attach the optional aluminum beveled edging. Remember; securing a screw means that
the top of the screw’s head is level with or below the floor surface. Do not tighten screws as explained
under, “ASSEMBLY INSTRUCTIONS” on page 10 of this manual.
NOTE:
A power drill may be used to secure screws only if it has a ratchet drive set at low torque
You should be ready to go. Have fun!
NOTE:
If you have the optional Beveled Edging and you are arranging a floor with inside corners, such as
an “L” or “T” shape,
beveled inside corner sets are available at
www.illumasquare.com
CLEANING & MAINTENANCE:
ILLUMA SQUARE is recommended for inside use only. You may setup ILLUMA SQUARE on any flat hard
surface.
Floor panels are water resistant but not waterproof. You may spill drinks and wet mop. All that is
needed to clean the acrylic surface is water and a clean rag. Never use anything abrasive.
Whatever does not come off with water can be easily removed with “Goof Off” remove
r and a clean rag.
We have tested many cleaners and recommend “Goof Off” brand professional strength remover (in the
yellow can). It can be used to clean any parts of the floor panels and trim. Simply wet a clean rag with
Goof Off and wipe.
ILLUMA SQUARE is a product of USA Dance Floor, LLC
Copyright USA Dance Floor, LLC
