VSG - 10
9
Check the power supply and the cables to be sure that they are not damaged.
Check that the emergency stop button is not pressed.
Troubleshooting
The machine will not run
Machine is too hard to hold onto - Tracks left or right
Not enough diamonds under the machine - Usually accompanied by high current
draw from the motor. (If grinding thick glue or soft floors, too few diamonds under the
machine will greatly increase the load on the grinder and the operator)
Increase the number of diamonds to reduce the load.
See “Levelling the Machine” on page 8
Diamonds may not be installed correctly or have different heights. Check to ensure
that all diamonds are fitted correctly and are the same segment height.
Machine is jumping around
The machine suddenly stops
Check the circuit breaker of the power source the machine is plugged into. Reset the
breaker if tripped. If the circuit was not tripped, check the VSG-10’s electrical panel.
The VSG-10 is equipped with a circuit breaker inside the electrical panel. Unplug the
machine from its power source. Open the elctrical panel and check the breaker to
see if it is tripped. If it is tripped, remove the weight and try grinding again.
THE FOLLOWING SYMBOLS AND DEFINITIONS ARE FOUND THROUGHOUT THIS
MANUAL AND ARE DESIGNED TO MAKE YOU AWARE OF POTENTIAL HAZARDS OR
UNSAFE PRACTICES.
A potentially hazardous situation exists which, if not
avoided, could result in death or serious injury.
A potentially hazardous situation exists which, if not
avoided, may result in minor or moderate injury or
property damage.
A potentially hazardous situation exists which, if not
avoided, may result in product or property damage.
THE FOLLOWING SYMBOLS & LABELS MAY BE FOUND IN THIS MANUAL OR ON THE TOOL.
Read the operator’s manual carefully and understand the
contents before you use this equipment.
Always wear a protective helmet
WARNING
IMPORTANT
CAUTION
Always wear protective glasses or full face protection
Always wear hearing protection
Always use ground fault protection
Always wear breathing protection
Never use damaged cables
Control Panel
Tripped Breaker
Ready Breaker
