802.11g 54Mbps USB Adapter User Guide
3. Type
Ping
followed by your IP address. To determine your IP address, refer to
the previous Possible Solution. This will ensure that your computer is responding
to requests and that the 802.11g 54Mbps USB Adapter is properly installed. If
you cannot complete this ping, uninstall the 802.11g 54Mbps USB Adapter and
repeat the installation procedure.
4. Type
Ping
followed by your gateway address to check the communication with
your gateway. The default gateway address is the IP address of your wireless
router or access point. Check your Wireless Router to verify this address. This
will ensure that you can connect to the Wireless Router. If you cannot complete
this ping, make sure your wireless settings are correct and that the 802.11g
54Mbps USB Adapter is fully inserted into a USB port on your computer.
5. Type
Ping
followed by the outside Internet address that is provided by your ISP.
This procedure will ensure that your wireless network can connect to the Internet.
If you cannot complete this ping, verify your Internet connection between your
modem and your wireless router or access point.
6. Type
Ping
followed by your known DNS server address. This will allow you to
resolve valid Internet host names to IP addresses and to verify that you can
access the Internet.
Security is enabled on my Wireless Router and my 802.11g 54Mbps USB Adapter
cannot connect.
Possible Solution:
The 802.11g 54Mbps USB Adapter supports 64 and 128 bit encryption. Verify that all of
the security features you have entered for the profile of your 802.11g 54Mbps USB
Adapter match the settings for your Wireless Router. For more information about setting
up connection profiles and security features, refer to the
section of this User Guide.
Possible Solution:
If you created a Profile Setting, unplug the 802.11g 54Mbps USB Adapter and then plug
it back in.
The U.S. Robotics Installation CD-ROM did not automatically launch when I
inserted the Installation CD-ROM.
Possible Solution:
Some programs may keep the autolaunch feature of the Installation CD-ROM from
beginning. Close any open applications and reinsert the Installation CD-ROM. If your CD-
ROM still does not automatically launch, click Windows
Start
,
Run
, and type
D:\setup
(if
your CD-ROM drive uses a different letter, type that letter in place of “D”) and click
OK
.
I accidentally clicked Cancel during the installation procedure.
Possible Solution:
Remove and reinsert the U.S. Robotics Installation CD-ROM into your CD-ROM drive.
Repeat the installation procedure of the software before you install any hardware.
My computer does not recognise the 802.11g 54Mbps USB Adapter.
Possible Solution:
The 802.11g 54Mbps USB Adapter may not be properly connected. Make sure the
802.11g 54Mbps USB Adapter is fully inserted into the USB Port on your computer.
The 802.11g 54Mbps USB Adapter does not work properly, and I may need to
uninstall the device.
Possible Solution:
file:///C|/Arcadyan/USR/SW/English/five.html 第 2 頁 / 共 5 2004/9/15 下午 05:34:58
