USR4204 User Guide
Page
18
of
52
Main Menu
At the top of the Main Menu is a banner that displays the current system parameters. Below
the banner are the menu name, the user-programmable device name, and the current login
name (if security is enabled). Next is a list of valid commands, text, and status. Invalid
commands are ignored.
Commands listed in this guide are shown within single quotes ('),
programmable names are shown within double quotes (")
'A'-'D' Connect to Console
A Connect command creates a full duplex data connection between the USR4204 terminal
port and one of its serial ports. The terminal port is fixed at 9600bps, 8N1. The rate and
format of serial ports are programmable to match the console port of the attached
equipment. The current serial port parameters are shown in parentheses next to the port
name.
To close a connection to a serial port, use the Escape Sequence. The Escape
Sequence consists of three identical characters typed rapidly without
surrounding characters. The default Escape character is "-" and is shown in
the banner on the Main Menu.
'1'- '2' Toggle Power Port
A Toggle command controls a power port. When a Toggle command is entered, power from
the mains power input is disconnected or reconnected to the corresponding output after
T/O Esc Menu Xon Xoff Flow Pass Echo AutoCR DCD Banr
005 - - ^Q ^S OFF OFF ON ON OFF OFF
----------------------------------------------------
MAIN Menu "USR4204 " Logged In: "Admin Username "
CMD
'A' Connect "Console A "( 9600 None )
'B' Connect "Console B "( 9600 None )
'C' Connect "Console C "( 9600 None )
'D' Connect "Console D "( 9600 None )
'1' Toggle "Power 1 "(ON 0.0 Amps)
'2' Toggle "Power 2 "(ON 0.0 Amps)
'Q' Toggle Cellular Mode (OFF)
'W' Arm Ctrl-B for Break
'X' Logout
'Y' Config Parameters
'Z' Config Ports
'-' Refresh MAIN Menu
