US drives AC Regen, Инструкция по эксплуатации, Страница: 2 / 20

Thank You
We at US Drives would like to say thank
you for purchasing our product. We
believe the Regenerative Module Series
is the most problem free product in the
market today. If you have any questions
or comments please feel free to call us.
On behalf of all of us here once again
thank you.
Recording Drive Information
It is a good idea to record all product
nameplate information for future reference.
The nameplate is usually mounted on the
side of the unit. The following tables should
be filled in during starting or prior to starting
the module.
Part Number
P/N
Serial Number
S/N
Software Revision Level
SRL
Branch Circuit Protection
Branch circuit protection must be provided
by the end user. In this manual you will find
recommended fuse sizes and types for
each module size.
Mounting Location
The unit should be installed in a well
ventilated, moisture free area. If there are:
fumes; vapors; dirt; lint;, liquids or gases
that can interact with the module, then a
clean air supply must be provided. The
ambient temperature should not exceed the
range of 14 F to 131 F (-10 C to 55 C). If
the unit will be subject to vibration then the
enclosure should be shock mounted.
Safety Warnings
Regenerative modules, like all electrical
equipment in industry, if not properly
installed and operated can cause personal
injury. Always use common sense when
working around electrical equipment. Make
sure you read this manual
before any work
on the unit begins. Never work on this
product if you are tired or under the
influence of any drug. The unit must be
grounded and installed in accordance with
National Electrical Codes (NEC) and any
local codes. Make sure that all power is
disconnected, before working on the
module.
Always measure the incoming
voltage at the unit to make sure it is zero
after disconnecting the power. Make sure
all air passages are clear for proper cooling.
After the unit is energized lethal voltages
are present.
Wait at least 5 minutes after
disconnecting power before working on
the module,
since high voltages will still be
present. Call us if you have any questions.
Maintenance
If the enclosure is subject to foreign
material, clean the enclosure and check
any filters for build up of debris. If the
inside of the enclosure needs cleaning, a
low
pressure vacuum cleaner is
recommended. Do not use an air hose
because of the possible oil vapor in the
compressed air and its high pressure.