9
RS485 Settings
Item
Description
Default
Enable
Enable/Disable serial interface
Enable
Interface Type
Set the interface type.
Select from RS485 (Modbus Master) and
RS232.
RS485
(Modbus
Master)
Interface 1 (Pin 1)
5/9/12V Output
Enable:
UC11-N1 will provide power to
the device connected to Interface 1
(Pin 1). Voltage is 5V, 9V or 12V.
Disabled
Power Output
Time Before
Collect
If the time is set 100ms, then before
collecting data from end nodes,
UC11-N1 will provide power for the end
node for 100ms.
Range: 1-5000 (ms).
Note: With this feature being enabled,
the power consumption will increase.
None
Baud Rate
Select from "1200", "2400", "4800",
"9600", "57600" and "115200".
9600
Data Bits
Select from "5", "7", "8".
8
Stop Bits
Select from "1", "2".
1
Parity Bits
Select from "Even", "Odd", "None".
None
Data Polling
Interval
Set the interval for reading remote
channels. When the reading cycle ends,
the new reading cycle begins until this
interval over. If it is set to 0, the device
will restart the new reading cycle after
all channels have been read.
Range: 0-86400 (s).
0
Execution Interval
(ms)
The execution interval between each
command. Range: 10-1000.
50
Max Resp Time
(ms)
Set the maximum response time that
the UC11-N1 waits for the response to
the command. If the device does not get
a response after the maximum response
time, it is determined that the
command has timed out. Range:
10-1000.
500
Max Retry Times
Set the maximum retry times after it
3
