5
E N G L I S H •
User's Manual
GENERAL SAFETY RULES
The Solar-Powered Auto-Darkening Welding
Helmet is suitable for most welding applica-
tions. This helmet’s 1/25,000-second switch time
automatically darkens the lens the moment you
start welding. No matter what shade the filter
is set to, the UV/IR protection is always present.
WARNING: ARC Rays can injure eyes and
burn skin.
FEATURES
KNOW YOUR PRODUCT
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
1. FRONT COVER LENS.
2. SOLAR PANEL.
3. HEADGEAR ANGLE & DISTANCE ADJUSTING
KNOBS.
4. UV / IR FILTER.
TECHNICAL DATA
USCS6
AREA OF VISION
98 mm × 62 mm
CARTRIDGE SIZE
115 mm × 133 mm
ARC SENSORS
4
UV / IR PROTECTION
DIN 16
VISION IN A CLEAR STATE
DIN 4
VISION IN DARK STATE (VARI-
ABLE SHADOW)
9 - 13 (external)
SENSITIVITY CONTROL
Low - High
DARKNESSING SPEED
1 / 25,000 s, from
light to dark
DARKENING DELAY
0.1 - 1.0 s
BATTERY TYPE:
SOLAR CELL
LITHIUM BATTERY (REPLACEABLE)
YES
2 x CR2450
UNDER TIG AMPERAGE
DC ≥ 5, AC ≥ 5
OPERATING TEMPERATURE
-5 °C to + 55 °C
STORAGE TEMPERATURE
-20 °C to + 70 °C
OTHER FUNCTION
ADF self-test button and low voltage indicator.
ADJUSTING INSTRUCTIONS
HEADGEAR ADJUSTMENT
1. Adjust the headgear
diameter with the twist
knob on the back. The
knob is locked until
pushed in. Once un-
locked, twist clockwise
to tighten and counter-
clockwise to loosen.
2. Adjust the height by
snapping the pin into
the hole to lock secure-
ly in place.
3. To adjust the viewing angle, loosen the knob
on both sides of the helmet and change angle
locker to the desired tilt position (5 selection
and positioned in the middle by default). Once
achieving the desire angle, tighten the knobs
until snug. The helmet should still swing up, but
it should not drift downward when in place for
welding.
4. To adjust the distance between the user’s face
and ADF, loosen the knobs on both sides of the
helmet until the headband can move back and
forth freely, reposition the headband at one
of the 3 slots as desired (The headband is posi-
tioned in the middle by default). This should be
done one side at a time and both sides should
be located at the same position for proper auto-
darkening filter operation.
OPERATION INSTRUCTIONS
SELF-CHECK
Press the TEST Button anywhere to see if it au-
tomatically switches to dark state and release it
to check that the filter returns to the light state.
SHADE CONTROL
Select the shade DIN 9 to 13 based upon the
welding process you will use by consulting the
“Shade Guide Table”. The variable shade con-
trol knob is for internal adjustment. The weld-
ing helmet can also be used to protect the face
when cutting, from shade DIN 5 to 8. Grind
mode DIN 4 prevents filter lens from auto-dark-
ening for grinding use.
NOTE: see page 7, it contains a shadow guide
table by type of operation.
2
3
4
1
