8
tempting. Before use of this product, familiar-
ize yourself with all operating features and
safety rules.
ASSEMBLY
Inserting/Replacing the Battery
The battery compartment holds two
“AA”batteries.
1. Push the latch to open the battery cover.
2. Insert two new “ AA” alkaline
batteries,following the polarity (+/-) as indi-
cated on the pole plate.
3. Securely close the cover.
NOTE:
• Always turn off the tool before installing or
replacing the batteries.
• Remove the batteries from the tool when not
using it for extended periods.
• The AA batteries should match each other in
brand and type.
• Do not mix old and new batteries.
• Remove depleted batteries immediately, and
dispose of them according to the laws and
regulations governing your community.
INITIAL OPERATION
Protect the measuring tool against moisture
and direct sun light.
• Do not subject the measuring tool to extreme
temperatures or variations in temperature. As
an example, do not leave it in vehicles for lon-
ger periods. In case of large variations in tem-
perature, allow the measuring tool to adjust
to the ambient temperature before putting it
into operation.
• Avoid heavy impact to or falling down of
the measuring tool. Damage to the measuring
tool can impair its accuracy. After heavy impact
or falling down, check the angle accuracy be-
tween the 0° and 90° laser line with the angle
of a precision square.
SWITCHING ON AND OFF
Push the power switch up to turn the self-
levelling cross-line laser level on, and slide the
power switch down to turn the tool off.
LEVELING FUNCTION
LASER LINE PROJECTION MODES
Your self-levelling cross-line laser level has
three laser-projection modes. To select an
specific laser-projection mode, press the mode
button until you reach the desired projection
mode. This laser tool defaults to the cross-hair
pattern mode when it is turned on.
To choose a projection mode, press the mode
button:
1. Press the button
once to select the cross-
hair pattern (horizon-
tal and vertical)
2. Press the button
twice to select the
horizontal laser line.
3. Press the button
three times to select
the vertical laser line.
Using your self-levelling cross-line laser level
Your self-levelling cross-line laser level has two
working modes Self-levelling mode and Lock
(manual) mode.
SELF-LEVELLING MODE
In this mode, the tool will level itself if it's
within ±4° of horizontal.
1. Place the self-levelling cross-line laser level
on a flat, smooth surface that is within ±4° of
horizontal.
2. Turn the tool on by sliding the power switch
to the up position. The self-levelling cross-line
laser level will automatically level within 5 sec-
onds .The LED indicator will shine green .
3. Press the mode button until the desired
laser-projection mode is achieved and the laser
line is projected from the laser aperture.
4. When the self-levelling cross-laser out of
levelling the LED will turn to red and the laser
line will blink.
5. To turn off the laser lines, slide the switch to
down position.
WARNING: When turning the laser on, al-
ways be aware of protecting your eyes and the
eyes of those around you. Never point the laser
light at anyone’s face, including your own.
Botón
NL2A manual.indd 8
07/03/17 12:11
