Urrea EA1005, Руководство пользователя и гарантия

Страница: 11 / 16

11
E N G L I S H •
User's Manual
The kickback is the result of an inappropri-
ate tool use or an incorrect operation. Can be
avoided following these instructions:
1. Keep a firm grip with both hands on the tool.
Position your body properly to resist the force of
kickback. The operator can control torque reac-
tions if the correct warnings are taken.
2. Never place your hand close to the rotating
accessory. It can cause a kickback over your
hand.
3. Never place your body on the kickback area;
the kickback will propel the tool to the opposite
direction of the rotation abrasive disc.
4. Use extra care when working with edges.
These tend to engage the disc.
5. Don’t use the tool with cutting saws. These
produce kickback.
FEATURES
KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
1. ON/OFF TRIGGER SWITCH
2. LOCK-OFF/LOCK-ON BUTTON
3. SPINDLE-LOCK BUTTON
4. GRINDING DISC
5. INNER FLANGE
6. DISC GUARD
7. SIDE HANDLE
8. POWER-SUPPLY INDICATOR LIGHT
TECHNICAL DATA
EA1005
VOLTAGE-FREQUENCY
120 V ~ 60 Hz
NO LOAD SPEED 11 000 r/min
DISC CAPACITY 5" (127 mm)
SPINDLE THREAD 5/8" (16 mm)
POWER 1 500 W
WEIGHT 3,5 kg (7,7 lb)
ASSEMBLY INSTRUCTIONS
WARNING: remove the grinder from the car-
ton and examine it carefully. Do not discard the
carton or any packaging material until all parts
are examined.
LATERAL HANDLE
The lateral handle must
be used always that
the machine is run-
ning. Screw the lateral
handle inside the holes,
could be on the right,
left or supe-
rior side. Your choice is determined by your
convenience and ability to keep the complete
control.
GUARD
The guard is a security device to prevent
injuries caused by pieces of abrasive disc.
1. Disconnect the plug
from the electrical out-
let.
2. Loosen the clamp
screws.
3. Position the guard at
the required angle.
4. Tighten the clamp
screws.
INSTALL AND REMOVE THE ABRASIVE DISC
To Install:
To install a disc:
1. Disconnect the plug from the electrical outlet.
Make sure that the guard (1) is securely in place.
2. Remove the out-
er flange (5).
3. Check that the
inner flange (2) is
properly seated on
the spindle. It will
click into place on
the spindle, and
will cause the spin-
dle to rotate when
the inner flange is
rotated.
4. Check the rated speed on the grinding disc
(4). Do not use a disc with a rated speed lower
than the speed shown on the grinder’s name-
plate.
NOTE: the maximum disc thickness is 1/4” (6,5
mm), and the spindle opening is 7/8” (22,3 mm).
5. Place the disc on the spindle.
7
5
4
2
1
3
6
1
2
3
4
5
6
7
8