6
DS1375-023
ENGLISH
WARNING!
For a functioning of the device it is strictly necessary that the iPerTAlk system version is
2.1.0
or higher.
1 DESCRIPTION
The device Ref. 1375/823 is an Elekta call module for iPerTAlk system.
The main features are:
• Signal management using 3.5” graphic colour display and evolved graphic user interface (GUI).
• Simultaneous lock with pulse capacitance discharge (SE+; SE-) and no-voltage contact relay (C-NC-
NO) operation.
• Garage gate lock low current operation (SE2).
• Hall button input.
• Door sensor input.
•
Audio repeat device control for use with hearing aid.
• LAN connection with RJ45 connector and POE power.
• Set-up by means of 2 terminals for local power supply.
•
125 kHz integrated transponder key reader
(future implementation)
.
•
Infrared proximity sensor for user detection.
• CCD colour camera with wide-angle lens.
• Alphanumeric keypad with 18 buttons, three of which multifunctional.
• Black glass design.
2 INSTALLATION
• Arrange wire conduits in order that they end in the lower holes of the flush mounting box.
• Fix the flush mounting box Ref. 1145/53 at the height shown.
• Fix the magnet (tamper) at the indicated height with the two-sided adhesive tape included
•
Make electric connections.
• Fix the call module to the flush mounting box.
•
Fix the front panel to the call module.
80 mm
1,55 ÷ 1,60 m
TAMPER
The highlighted part of the magnet must face the wall of the box (in contact with the two-sided
adhesive tape).
