DS1092-533A
5
INSTALLATION INSTRUCTIONS
•
Arrange a suitable circuit breaker and fuse upstream of the devices.
•
Make sure that the rating plate data corresponds to the power specifications before connecting the
device to the mains.
INSTALLATION
•
Make sure that no units are powered before starting the installation procedure..
•
Measure the camera shooting range and find the best position for the infrared illuminator.
•
Adjust the infrared illuminator pan/tilt, in order to align it to the camera.
•
Make sure the available mains power supply is compliant with product specifications.
•
Install the power supply cables according to standard safety regulations.
•
It is suggested to install the illuminator at a height of 3 or 4 metres about from the floor. If installed too
high, the result may have less effect.
•
If the device falls or is damaged in any way, avoid to use it. Contact the authorized technical service
centre before activating it again.
•
Avoid to pull excessively the power supply cable, in order not to damage the device.
OPERATING FEATURES
IR LED operation
The device is provided with a CDS sensor that switches the IR LEDs on when the light is less than
approximately 10 Lux.
CLEANING THE DEVICE
Rub delicately with a dry cloth to remove dust and dirt. Dip the cloth in neutral detergent if dirt cannot be
eliminated with a dry cloth alone. Do not use volatile liquids (such as petrol, alcohol, solvents, etc.) or
chemically treated clothes to clean the device to prevent deformation, deterioration or scratches to the
surface finish.
