urmet domus 1067/024, Руководство по установке

Страница: 77 / 120

DS1067-063D
77
LBT20064
5.11.3 The 1067/092 board
The 1067/092 electronic board has two distinct sections: BUS IN and BUS OUT, galvanically isolated to guarantee better
immunity to RF disturbances.
In the BUS IN section there is an 1067/008A integrated expansion (
E ).
In the BUS OUT section there is an integrated repeater function ( R ) and power supply ( P ).
Figure 54 - 1067/092 Board
5.11.3.1 The Expansion
By referring to the Figure 54 - 1067/092 Board , the functions of the terminals, LEDs, and buttons dedicated to the
Expansion are the following:
Terminal board Group Description Connection / Function
M1
BUS
IN
+ Expansion power supply via bus
+D
BUS Data transmission/reception
D
─
Expansion power supply via bus
M2 Outputs
+V1
Power supply for output actuators (limited to 500 mA)
-V1
NC1 Relay output 1
– contact normally closed
NO1 Relay output 1
– contact normally open
C1 Relay output 1
– common (max. 1 A - 24 Vdc)
U2
Electric output 2 can be configured
(protected from short circuit - I max 10mA)
U3
Electric output 3 can be configured
(protected from short circuit - I max 10mA)
M3 / M4 Inputs
+V2
Power supply for detectors (limited to 500 mA)
-V2
IN1
Alarm input n. 1
IN2 Alarm input n. 2
IN3 Alarm input n. 3
IN4 Alarm input n. 4
IN5 Alarm input n. 5
IN6 Alarm input n. 6
IN7 Alarm input n. 7
IN8 Alarm input n. 8
SAB
24h input (for system self-protection), must always be BALANCED
and closed with a 2.7 k
Ω balancing resistor
TAMPER
Tamper Connector for connection of the tamper
JP1
Jumper for the exclusion of the tamper
(Jumper inserted = tamper excluded)
PROG Button and LED Button and LED (yellow) for programming
RUN LED Green LED to signal operation
M1
M2
M3 M4
M5 M6
M8
M7
E P
R