Network Installation
The HCM-C1 Base Station can be installed using a Wi-Fi wireless Ethernet
connection, or a traditional hard-wired ethernet connection.
When installing the base station for the first time, perform one of the two following
steps:
Wireless Connection
• Connect the HCM-C1 Base Station to your wireless access point by using the
WPS button, and your wireless access point.
• When successfully connected to the wireless access point, the Wi-Fi LED on the
Base Station will glow either green, yellow or red, based on Wi-Fi signal
strength. Setup is now complete. If you wish to set specific network settings, see
section below.
Or
Hard-wired connection
• Connect the HCM-C1 Base Station to the local Ethernet network via a wired
Ethernet connection.
When the Status LED illuminates, use the HCM-R1 Remote Control to set the
network properties of the HCM-C1 Base Station.
Note that the HCM-R1 Remote Control is required to be on the same local Ethernet network as
the HCM-C1 Base Station to set the network properties of the HCM-C1 Base Station.
Page
14
