A L T A M O N T
A L T A M O N T
A L T A M O N T
A L T A M O N T W E T
W E T
W E T
W E T
ASSE M BLY AND M O UNTING INSTR UCTI O NS
D C - 1 2 2 0
M O U N T I N G I N S T R U C T I O N S
M O U N T I N G I N S T R U C T I O N S
M O U N T I N G I N S T R U C T I O N S
M O U N T I N G I N S T R U C T I O N S
STEP 1
STEP 1
STEP 1
STEP 1
SHUT OFF THE MAIN ELECTRICAL SUPPLY TO THE JUNCTION
BOX FROM THE FUSE BOX/CIRCUIT BREAKER. TURNING
POWER OFF AT THE SWITCH IS NOT SUFFICIENT.
STEP 2
STEP 2
STEP 2
STEP 2
LOCATE THE JUNCTION BOX ON THE WALL. ATTACH THE
PROVIDED CROSS BAR TO THE JUNCTION BOX USING THE
JUNCTION BOX SCREWS.
STEP 3
STEP 3
STEP 3
STEP 3
USING THE WIRE NUTS PROVIDED, MAKE ELECTRICAL
CONNECTIONS BY FOLLOWING THE ELECTRICAL CONFIGURATION
TABLE BELOW. ENSURE THAT ALL ELECTRICAL CONNECTIONS
ARE WRAPPED WITH UL LISTED ELECTRICAL TAPE.
STEP 4
STEP 4
STEP 4
STEP 4
ATTACH THE FIXTURE TO THE CROSS-BAR USING THE CAP &
CHECK RING PROVIDED. BE CAREFUL TO AVOID SCRATCHING
THE FINISH ON THE FIXTURE.
STEP
STEP
STEP
STEP 5
5
5
5
INSTALL LIGHT BULB IN FIXTURE SOCKET AND RESTORE POWER
TO THE CIRCUIT. CONFIRM PROPER OPERATION OF THE LIGHT
FIXTURE.
STEP
STEP
STEP
STEP 6
6
6
6
TO INSTALL GLASS, REMOVE THE TWO SCREWS THAT FASTEN
THE TOP CAP TO THE FIXTURE FRAME AND SET ASIDE.
