1of2
Package Contents
Tools
Required:
Flathead
screwdriver,
Phillips
screwdriver,
pliers,
wire
cutters,
wire
strippers,
electrical
tape,
safety
glasses.
Light
Source:
(1) A21
Medium
Base
bulb
150W
Maximum.
Estimated
Assembly
Time:
20-30
minutes
Preparation:
Identify
and
inspect
all
parts
before
beginning
installation.
Check
package
content
list
and
diagrams
below
to
be
sure
all
parts
are
present.
If
any
parts
are
missing
or
damaged,
do
not
attempt
to
assemble,
install,
or
operate
the
fixture.
Contact
customer
service
for
replacement
parts.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
A
Mounting Screw
x 3
Fixture
Body
x 1
B
Fixture Hood
x 1
C
D
Lock Ball
x 2
STEP 1
Install Bulb and
Fixture Hood
-
A. Insert bulb into socket and
screw snugly into place
B. Place the bolts on the
bottom edge of the Fixture
Hood (B) through the holes
on the top edge of the
Fixture Body (C) and secure
with Lock Balls (D). Hand
tighten until sung.
Figure 1
STEP 2
Drill Pilot Holes on Post
-
A. Carefully fit the Post Fitter over the end of the
Post (not supplied), making sure the Post
Fitter is fully seated.
B. Mark the drill point for the (3) Mounting
Screws, using (3) Mounting Holes as
reference. After marking hole locations,
remove fixture from post and drill 1/16” pilot
holes for screws.
Post
Post Fitter
Figure 2
Mounting Hole
White wire
from supply
White wire
from fixture
Black wire from
supply (or Red)
Black wire
from fixture
Ground wire
from supply
Ground wire
from fixture
Figure 3
STEP 3 - Wire Connections
A. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined
together. Wrap each connection with approved electrical tape and
carefully stuff all the connected wires into the Outlet Box.
STEP 4
Attach Fixture Body to Post
-
A. Coat the top 1” of the Post with Clear
Silicone Caulk (not supplied) and
position the Post Fitter onto the Post. Be
sure to seat it completely, aligning the
holes in the Fitter with the 1/16” Pilot
Holes drilled into the Post.
B. Secure the Fixture to Post with (3)
Mounting Screws (A).
Your fixture is now assembled and
ready to use. Enjoy!
Post
Post Fitter
Figure 4
Mounting Hole
A
B
C
D
Bulb (not
supplied)
Socket
Installation Instructions:
UQL
1053
www.urbanambiance.com
