WARNING: IF YOU DAMAGE OR DISABLE THE INTERNAL LOCK-
ING PIN WHICH NORMALLY ASSURES THAT YOUR URB-E SPORT
SERIES IS TURNED OFF WHEN REMOVING OR REINSTALLING
THE BATTERY, STOP USING YOUR URB-E SPORT SERIES UNTIL
THE DAMAGE TO THE PIN IS REPAIRED. USING THE URB-E SPORT
SERIES BEFORE IT IS REPAIRED MAY RESULT IN SPARKING,
OTHER ELECTRICAL MALFUNCTION, UNINTENDED BATTERY
MOVEMENT WHILE RIDING, AND MAY LEAD TO SERIOUS INJURY
OR EVEN DEATH.
Charging Your URB-E
Sport Series
1. Turn the URB-E SPORT SERIES off before charging.
2. Connect the charger to the EDDY and then plug the charger into a standard
110V or 220V wall outlet. Check to make sure the LED light on the charger lights
up. The LCD Display on the EDDY will show a flashing arrow while charging.
3. The LED light on the charger will turn from red to green once the URB-E
SPORT SERIES is fully charged. The percentage screen will also read 100%
when fully charged.
4. Unplug the charger from the outlet and do so promptly after charge is
complete.
REMOVING YOUR BATTERY
To remove EDDY, push in and turn the key counter-clockwise completely to the
left past the “OFF” position to the “UNLOCK” position, and remove the key. This
will retract the internal locking pin, allowing the battery to be removed from the
base.
Once the internal locking pin has been retracted, pull firmly on the attached
leather strap to remove the battery from its base.
When the URB-E SPORT SERIES is on, the LED lights
on the throttle will turn on, indicating current charge
status of the battery.
Green: Full / Yellow: 75% / Red: 50% and less
Battery charge level can also be checked on the
charge percentage screen located on the top left side
of EDDY when the key is turned to the “ON” position, or
when EDDY is connected to the wall charger.
11.
