Upright SL26SL, Руководство по обслуживанию и запасным частям

Страница: 27 / 104

SL26/30SL Work Platform 3-3
M
AINTENANCE
Section
3.4
3.4 B
LOCKING
E
LEVATING
A
SSEMBLY
(F
IGURE
3-1)
Installation
1. Park the work platform on firm, level ground and
leave the engine running.
2. Open control module cover.
3. Turn Chassis Emergency Stop Button clockwise
to the ON position.
4. Position Chassis Lift/Lower to UP and elevate
platform approximately 305 mm (12 inches).
5. Place a jackstand with a minimum rating of 1814
kg (4000 lbs.) between the lower mast and chas-
sis, just behind the front axle.
6. Push Chassis Lift Switch to DOWN position and
gradually lower platform until jackstand is
secured tightly between lower mast and Chassis.
Figure 3-1: Blocking Elevating Assembly
Removal
1. Push Chassis Lift Switch to UP position and grad-
ually raise platform until jackstand can be
removed.
2. Remove jackstand.
3. Push Chassis Lift Switch to
DOWN position and
completely lower platform.
3.5 B
ATTERY
M
AINTENANCE
Battery Inspection & Cleaning
Check battery fluid level daily, especially if work plat-
form is being used in a warm, dry climate. If required,
add distilled water ONLY. Use of tap water with high
mineral content will shorten battery life.
The battery and cables should be inspected regularly
for signs of cracks in the case, electrolyte leakage
and corrosion of the terminals. Inspect cables for
worn spots or breaks in the insulation and for broken
cable terminals.
Clean the battery when it shows signs of corrosion at
the terminals or when electrolyte has overflowed dur-
ing charging. Use a baking soda solution to clean the
battery, taking care not to get the solution inside the
cells. Rinse thoroughly with clean water. Clean bat-
tery and cable contact surfaces to a bright metal fin-
ish whenever a cable is removed.
C A U T I O N
! !
DO NOT support or raise the front of the plat-
form during any maintenance operation as this
may result in damage to the tension members.
W A R N I N G
! !
BEFORE performing, maintenance on work
platform, while elevated, ensure that elevating
assembly is properly supported.
DO NOT stand in elevating assembly area while
installing or removing jackstand.
W A R N I N G
! !
Hazard of explosive gas mixture. Keep sparks,
flame, and smoking material away from batter-
ies.
Always wear safety glasses when working with
batteries.
Battery fluid is highly corrosive. Thoroughly
rinse away any spilled fluid with clean water.