Uponor SETPOINT 500 SERIES, Руководство пользователя, Страница: 6 / 8

Setting the Mode of Operation
There are several modes of operation available depending on the type of
controller installed and its setup. Follow the steps below to select the mode
of operation.
1. Press and release the Menu button until the Adjust menu displays.
2. Use the up or down arrow buttons to select between the Off, Heat, Cool
(512 only) and Auto (512 only) settings.
Off — In the Off mode, the controller does not operate the heating device.
Heat — In the Heat mode, the controller operates to maintain the room at
the required heating temperature.
Cool — This mode is only available with the SetPoint 512 that is set up
for heating and cooling. In the cool mode, the SetPoint 512 operates to
maintain the room at the required cooling temperature and ensures that
the heating does not turn on.
Auto — This mode is only available with the
Setpoint 512 that has been set up for heating
and cooling. This mode allows the SetPoint 512
to automatically switch between heating and
cooling the room as the air temperature requires.
If a slab or floor sensor is installed, the floor
maintains the minimum slab or floor temperature
even during cooling.
7
SetPoint 500 Series Controllers User Manual
Follow the steps below to select the away override.
1. Press and release the Menu button until the Schedule (SCHD)
menu displays.
2. Use the up or down arrow buttons to select the away override.
Canceling the Away Override (501s, 511s and 512 Only)
Follow the steps below to cancel the away override.
1. Press and release the Menu button until the Schedule (SCHD)
menu displays.
2. Use the up or down arrow buttons to select the None setting.
Display Lighting (511s and 512 Only)
The display on the controller has a backlight setting. The backlighting can
be turned on, turned off or set to operate temporarily for 60 seconds after
any button is pressed. Follow the steps below to set the display lighting.
1. Press and release the Menu button until the Adjust menu displays.
2. Press and release the Item button until the word LITE displays.
3. Use the up or down arrow buttons to select
On, Tmpy (temporary) On or Off.
Note: If the backlight setting is temporary,
the first press of a button turns on
the backlight.
Setting the Units of Temperature
Follow the steps below to select between Fahrenheit and Celsius.
1. Press and release the Menu button until the Adjust menu displays.
2. Press and release the Item button until the
current temperature unit begins to flash.
3. Use the up or down arrow buttons to select
between Fahrenheit and Celsius.
6