© UPLIFT Desk
• 800-349-3839 • [email protected] • upliftdesk.com
Copyright Notice:
This guide is a component of this accessory. This guide is a part of the scope of delivery, even if the item is resold. This guide is also available on the UPLIFT Desk website: upliftdesk.com. Excerpts or
copies may not be forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk. These instructions are subject to United States copyright law.
©
AI-ACU015-1.2
90.014.01.0785v.A
CAUTION:
Read all instructions before assembly. Failure to assemble properly may result in
damage or personal injury.
CAUTIONS & WARNINGS
!
!
Step 5
Depending on ceiling height, you may need to tip the frame as
-
sembly on its side for this step.
When the frame height is set, slide one of the panels into one
side of the frame through the Side caps and bottom of Lower
post as shown. Once the first panel is in place, push the Side
caps up against the edges of the panel and tighten the two
screws from Step 3.
Then install the second panel in the same way as the first panel,
but on the opposite side of the frame.
Finally, align the Top cap with the center of the tops of the pan
-
els and press into place so it is flush with the tops of the panels.
This will keep the panels parallel and keep them from bowing
over time.