© UPLIFT Desk
• 1-800-349-3839 • [email protected] • www.upliftdesk.com
The UPLIFT Adapt Mobile allows you to run cables from your tray, down the arm,
and to the back of your desk.
a. Pull the four tabs out of the cable cover on the upper section of the arm
b. Pull up and out on the cable cover on the lower section of the arm
c. Run your cables through the exposed section of the arm.
Make sure that there is some
slack in the cables to allow the arm to freely move.
d. Trap the cables under the cable cover on the upper section of the arm and snap it back
into place, and slide the cable cover over the wires in the lower section of the arm
Cord Management
a.
b.
c.
d.
Moving the arm, and counterbalancing
180°
360°
270°
You can adjust the angle and position of your tray by simply moving it to
the position you desire. If you find that the after you place your laptop on
the tray that it either lifts or drops, then you need to counterbalance your
UPLIFT Adapt Mobile.
With your laptop (or object of identical weight) on the tray, use the
large Allen wrench to adjust the tension adjustment screw located at the
middle joint of the arm. Turn toward the “-” if your arm will not adjust to
a lower position and turn toward the “+” if your arm will not adjust to a
higher position. When the arm stays in place after you’ve adjusted it, your
UPLIFT Adapt Mobile is properly counterbalanced.
