© UPLIFT Desk
• 1-800-349-3839 • 1-512-614-3152 • [email protected] • upliftdesk.com
4
Step 2
On the third Leg (C1) connect the Corner end (C5) to
the LEFT SIDE as shown, attaching it only with two (2)
of the M6x35 screws (H6).
Rotate each screw by hand for only a few turns to
avoid cross-threading.
Do not tighten fully until step 3.
Step 1
Place each Leg (C1) and over the edge of a table.
Connect a Frame end (C4) to each leg. For the first
two legs, attach using four (4) M6x14 screws (H1).
(see figure 1)
For the third leg, attach using only two (2) of the
M6x14 screws (H1) on the RIGHT SIDE ONLY.
(see figure 2)
Rotate each screw by hand for only a few turns to
avoid cross-threading.
Do not tighten fully until step 3.
(fig. 1)
(fig. 2)
ASSEMBLY INSTRUCTIONS
C4
C4
C5
H1
H1
H1
Step 3
Place all leg assemblies upside down on the floor. For
the first two leg assemblies, Place the Side brackets
(C8) against the rear of the Frame ends and attach
using four (4) M6x14 screws (H1).
On the Corner leg assembly, connect the Corner
bracket (C9) using two (2) M6x35 screws (H6).
Rotate each screw by hand for only a few turns to
avoid cross-threading.
Once all screws from steps
1, 2, and 3 are holding the Leg assemblies together,
tighten all screws using the 4mm Allen wrench (H6).
Step 4
Remove backing from Adhesive pads (H4) and posi-
tion along the brackets and frames as shown. Be sure
to not cover any holes for the screws!
H1
C8
C9
C1
C1
H4
H6
H6
