Step 2 - Perform Desk Reset Procedure
IMPORTANT:
Before using your desk, perform the following Desk Reset to ensure the desk legs are calibrated properly
after assembly.
A. Hold the DOWN button until the desk reaches its lowest height and then release the button.
B. Press and hold the DOWN button again for up to 15 seconds, then release the button.
C. Press and hold the DOWN button again until the desk lowers slightly then rises slightly. Release the button. If the desk
didn’t move, try the reset procedure again.
D. Your desk is now ready for use!
Optional Desktop Drilling Instructions:
If you are using your own desktop
or you would like to attach the keypad in a different location than the pre-
drilled holes, position the keypad on the desktop and make a pencil mark at
the center of each keypad mounting hole. Drill no deeper than 1/2” into the
desktop to prevent damaging the desktop surface (we recommend wrapping
a piece of tape around your drill bit 1/2” from the tip and stopping just before
the tape touches the desktop). Drill pilot holes using a 1/8” drill bit.
X
0.5”
Tape
Step 3 - Keypad Settings &
Programming
Scan the QR code or visit https://www.
upliftdesk.com/desk-assembly-and-
programming/ to see Settings and
Programming instructions.
with questions | ©2022
UPLIFT Desk
®. All Rights Reserved
AI-FRM002-1.0
JC #XXXXXX
Safety and Warnings
See the Safety and Warnings listed
on the assembly instructions
included with your desk frame
Safety and Warnings
See the Safety and Warnings listed
on the assembly instructions
included with your desk frame.
