Moving the arm, and counterbalancing
360°
© UPLIFT Desk
• 1-800-349-3839 • [email protected] • www.upliftdesk.com
Using Cord Management
a.
b.
You can adjust the angle and position of your monitor by simply moving
it to the position you desire. If you find that after you mount your monitor
that it either lifts or drops, then you need to counterbalance your UPLIFT
Adapt Mobile.
Use the large Allen wrench (part G) to adjust the tension adjustment screw
located at the middle joint of the arm. Turn toward the “-” if your arm will
not adjust to a lower position and turn toward the “+” if your arm will
not adjust to a higher position. When the arm stays in place after you’ve
adjusted it, your UPLIFT Adapt Mobile is properly counterbalanced.
180°
360°
270°
The UPLIFT Adapt View™ line allows you to run cables from your tray, down the arm,
and to the back of your desk.
a. Pull the four tabs out of the cable cover on the upper section of the arm
b. Pull up and out on the cable cover on the lower section of the arm
c. Run your cables through the exposed section of the arm.
Make sure that there is some
slack in the cables to allow the arm to freely move.
d. Trap the cables under the cable cover on the upper section of the arm and snap it back
into place, and slide the cable cover over the wires in the lower section of the arm
