Unold 28495, Инструкция по эксплуатации

Страница: 21 / 80

21
prograMMing the fill quantity
1. When programming the fill quantity, make
sure that there is enough milk in the milk
tank and always place a large enough con-
tainer under the milk spout.
2. To reset the appliance to the factory setting,
press buttons A and B simultaneously for
3 seconds.
hot milk
3. You can change the quantity and duration
for preparation of the milk. With the factory
setting, the appliance prepares 150 ml of
hot milk in 30 seconds.
4. Press the A button for about 3 seconds until
the button starts to flash.
5. The appliance prepares hot milk until you
press the A button again.
6. From this point on, the appliance will always
prepare this amount of hot milk. The setting
can be adjusted from 5-60 seconds. When
set to 60 seconds the appliance prepares
about 300 ml of hot milk.
Frothed milk
1. You can change the quantity and duration
for preparation of the milk. With the factory
setting, the appliance prepares 100 ml of
frothed milk in 20 seconds.
2. Press the B button for about 3 seconds until
the button starts to flash.
3. The appliance prepares frothed milk until
you press the B button again.
4. From this point on, the appliance will always
prepare this amount of hot milk. The setting
can be adjusted from 5-30 seconds. When
set to 30 seconds the appliance prepares
about 100 ml of hot milk.
energy saVing (stanD-by) MoDe
1. If you do not use the appliance for 5 minu-
tes it automatically switches to stand-by
mode. All three buttons light up one after
the other.
2. To leave stand-by mode, press either button
A or B briefly.
3. You can extend the time after which the
appliance switches to stand-by mode to 30
minutes. To do this, switch the appliance
off.
4. Press the B button and switch the appliance
on. Keep the B button pressed until all but-
tons light up. Now the appliance will switch
to stand-by mode after 30 minutes.
5. If you wish to reset this setting to 5 minu-
tes, proceed as described above, but keep
button A pressed until all the buttons light
up.
safety function
If the front cover or the milk tank are removed from the appliance, the CLEAN button flashes quickly
and the appliance will not prepare any more milk.
cleaning anD care
For hygienic reasons, the appliance
must be cleaned immediately after
every use. Otherwise, the remnants
of the milk could foster the growth of
health-harming germs.
Before you use the appliance cleaning program:
1. Fill the water tank with fresh, cold tap water
(max. 600 ml) and insert the tank in the
appliance.
2. Remove the milk tank from the appliance
and insert the cleaning cup.
3. To clean the appliance thoroughly, also fill
the milk tank with water (at least 200 ml,
but not more than 600 ml of water).
short cleaning program
4. Before the first daily use of the appliance
and in between, if the appliance has not
been used for longer than 30 minutes.