04
Instruction to wash the machine :
.
Switch OFF the machine.
. Withdraw the Lid No. 01 (Pic.02) and the Bowl No. 02 (Pic.02 ).
. Wash all parts with water and soap , except the Cabinet No. 03(Pic.02).
. To assemble the parts back , follow the inverse pass .
To clean the Cabinet use an alcohol wet cloth .
4. General Safety Advices
The General Safety Advices were prepared to properly instruct the
operators and the maintenance team .
The machine shall only be given to the operators in good working
conditions and they shall be properly oriented by the dealer, about how to use it with
safety .
The operator shall only use the machine after a complete knowledge
of the cares to be taken when operating the machine , carefully reading all this
Instruction Manual .
4.1.1 Dangers
Some parts of the machine electrical commands have high voltage
points or terminals . These when touched , may produce severe electric shocks , and
even DEATH .
Never touch a manual command ( button , electric switch, etc ) with wet
hands , shoes or clothes. If this warning is not followed electric shocks and even
DEATH , may occur .
4.1 Basic Operation Procedures
Important
When cleaning the Bowl inside watch the knife blades because they are very
sharp .
01
02
03
01 . Lid
02 . Bowl
03 . Cabinet
05
4.1.2 Warnings
The Switch ON/OFF position must be well known , to allow to be used
without to look for it .
Before to proceed to any maintenance , unplug the machine from the
electric network .
Provide enough space around the machine to avoid falls .
Water and oil may produce a dangerous and slippery floor . To avoid
accidents the floor shall be dry and clean .
Never use a manual command ( button , switch , lever , etc ) unadvisedly .
If any work has to be done by more than one person , coordination signs
shall be accorded , for each step of the work . Next step shall not be started without the sign
is given and acknowledged .
4.1.3 Advices
Be sure this Manual INSTRUCTION has been fully understood . Each
function or operation procedure has to be perfectly clear .
Any manual command ( button , pulses , electric switch , lever, etc ) shall be
given only after to be sure it is the correct command .
If an electric supply failure happens , the machine shall immediately be
switched OFF .
Avoid any strikes on the machine , since they could produce failures or a
bad performance .
Avoid water, dust or dirt to get inside the electrical or mechanical
components of the machine .
DO NOT CHANGE the machine original characteristics .
DO NOT TEAR, WITHDRAW OR GET DIRTY , ANY SAFETY OR
IDENTIFICATION LABEL . If a Label is lost or unreadable ask for a new one to your Dealer .
4.2 Cares before to start the Blender
IMPORTANT
Read carefully this INSTRUCTION before to start the machine . Be sure it has
been correctly understood . If any doubt arises contact the department Chief
or the Dealer .
4.2.1 Danger
Electric wires must have a perfect insulation, any damage may cause an electric
shock .
Before to use them be sure they are in good conditions .
