MRf-350 b
ase
s
TaTiOn
Page 2
Features and Benefits
interference Rejection and extended Rf Range via RfX-250
The MRF-350 receives RF (radio frequency) signals via the RFX-250 RF Sensor.
The RFX-250 displays RF interference via a bright red LED, which flickers when
interference is present. Simply relocate the RFX-250 out of the interference.
expand Range by adding RfX-250 Rf sensors in Remote areas
The MRF-350 can power up to three RFX-250 RF Sensors connected in parallel to
the RF Input connector.
Variable iR Output Matches Rear Panel iR inputs
The MRF-350 is equipped with adjustable IR line outputs, each output can be indi-
vidually matched to rear panel IR inputs on any component that is designed to
be operated by a standard IR repeater. The outputs utilize a 3.5mm jack.
Up To fifteen equipment locations With identical Components
Each MSC System remote is “addressable.” They can be programmed to specifi-
cally control components in a particular room by installing a base station at each
location. In operation it’s simple: when you select a device located in the Den,
the MX series remote only sends commands to the Den. When you select a
device located in the Family Room, the MX-3000 only sends commands to it.
a single MRf-350 Can Control an array of identical Components
or identical Zones of a Multi Zone Preamp/Matrix switcher
Each MRF-350 has six “addressable” IR Line Outputs. For example, you can con-
trol up to six identical TV’s with one MRF-350 or route volume commands for a
specific zone to a particular zone IR input on a multi-zone preamp. If you have
more than six identical components or zones, up to 15 additional MRF-350s can
be installed to control them (thus allowing up to 90 identical components or
zones in one house).
iR input for Keypads or iR Repeater systems
The MRF-350 rear panel IR input will relay IR Data from IR repeaters or Multi-
Zone Keypads to all IR line outputs (does not support IR routing). The 5V, 100
milliamp output will directly power some brands and models of keypad directly.
Parts Guide
1 - RFX-250 RF Sensor with integrated
antenna
1 - Mounting plate for RFX-250
1 - MRF-350 Base Station
1 - Mounting Plate for wall mounting the
MRF-350
8 - Screws for wall mounting the two
mounting plates
1 - 9V-300mA Power Supply
6 - Visible Flashers with 10 foot plug in cables.
6 - Extra self adhesive pads for Emitters
1 - 12’Connecting Cable
1 - Adjustment Tool (Screwdriver for RF ID
and IR level adjustment)
2 - Depluggable screw connectors for RF con-
nections when extending wires.
