FLORIDA-PNEUMATIC.COM
Please contact 1-800-356-3392 for further assistance.
Safety Information (continued)
AIR COMPRESSOR AND AIR TOOL SAFETY
1. Risk of Bursting. Do not adjust the regulator to result in output
pressure greater than the marked maximum pressure of this air
tool.
2. Ensure the hose is free of obstructions or snags. Entangled or
snarled hoses can cause loss of balance or footing and may
become damaged.
3. Never leave a tool unattended with the air hose attached.
4. Do not operate this tool if it does not contain a legible warning
label.
5. Do not continue to use a tool or hose that leaks air or does not
function properly.
6. Never direct a jet of compressed air toward people or animals.
7. Protect your lungs. Wear a face or dust mask if the operation is
dusty.
WARNING:
Some dust created by power sanding, sawing,
grinding, drilling and other construction activities contains
chemicals known to cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals are:
Lead from lead based paint, crystalline silica from bricks
and cement and other masonry products, arsenic and
chromium from chemically-treated lumber.
Your risk from those exposures varies, depending on how
often you do this type of work. To reduce your exposure to
these chemicals: work in a well-ventilated area, and work
with approved safety equipment, such as dust masks that
are specifically designed to filter out microscopic particles.
Important Warnings - Impacts
Specifications
1. Eye protection and hearing protection and safety gloves must always be worn when operating an impact wrench or impact
driver.
2. When using heavy impact sockets or sockets on impact wrenches with 3/4” drive anvils or larger, a socket retaining ring
and pin should be used to prevent the socket falling off and causing injury.
3. Use only impact sockets and accessories. Only use sockets designated “FOR USE WITH IMPACT WRENCHES”, hand tool
sockets can break, creating a hazard from flying pieces. Always check sockets, retainers and drives regularly for wear or
damage and replace when necessary.
Accessory Hazards
4. Disconnect the assembly power tool for threaded fasteners from the energy supply before changing the inserted tool or
accessory.
5. Do not touch sockets or accessories during impacting as this increases the risk of cuts, burns or vibration injuries.
6. Use only sizes and types of accessories and consumables that are recommended by the assembly power tool for threaded
fasteners manufacturer; do not use other types or sizes of accessories and consumables.
Working
Working Max Torque Max Torque Speed
Socket
Weight Weight Length Length
Rec
Air Inlet Hose Air Cons Average
Model
Torque (ft. lb.) Torque Nm
(ft. lb.)
(Nm)
(RPM)
Anvil
Retainer
Exhaust
(lb.)
(kg)
(in.)
(mm)
Pressure
(NPT) (I.D. in.) (cfm)
(cfm)
UT8085R
35-205
48-278
320
433
12,000 3/8" Square Friction Ring Handle
2.85
1.3
5.20
132
90 psi-6.2 bar 1/4" 3/8" 20 9.4
UT8085P
35-205
48-278
320
433
12,000 3/8" Square Spring Pin
Handle
2.85
1.3
5.20
132
90 psi-6.2 bar 1/4" 3/8" 20 9.4
Vibration Level (m/sec2): 7.80
Noise Level (dBA): 89.66
