FLORIDA-PNEUMATIC.COM
Please contact 1-800-356-3392 for further assistance.
Operation
1
Operating the horizontal grinder
This Horizontal Grinder is designed to operate on 90 PSIG.
Lower pressure (below 90 PSIG) will reduce performance
of the tool. Higher air pressure (over 90 PSIG) raises the
performance of the tool beyond its rated capacity and
could cause serious damage to the tool and the user.
This tool features a safety lock-off mechanism.
2
Install /remove cone wheel
WARNING:
Disconnect the tool from the air supply before
servicing or changing accessories.
3
Install / remove the grinding wheel
4
Grinding and deburring
To install cone wheel, turn clockwise onto the threaded spindle.
To remove cone wheel, turn counter-clockwise to remove cone
wheel.
Install the grinding wheel.
Connect the grinder to the air supply.
This tool features a safety lock-off mechanism.
Operate the tool by disengaging the safety lock-off
mechanism and depressing the throttle lever to run the tool
for grinding or deburring.
WARNING:
You must wear the ANSI approved eye
protection during the operation; failure to follow this this may
result in serious injury or damage to the operator.
WARNING:
Hearing protection is strongly recommended. A
protective respirator is recommended.
Remove the grinding wheel.
