6
or open. If a component is placed too far away from the front
blaster, you will need to utilize the included flashers plugged
into the MRF-100 rear flasher jacks.
If you have problems with components that are close to the
front blaster, try repositioning the the MRF-100 farther away.
Step 7 - Connect Flashers to Out-of-Sight A/V Components
Note:
Test the operation BEFORE sticking the flasher in place.
Use a flashlight to identify the correct location of the compo-
nent’s IR sensor, then try a few commands while moving the
flasher around the face plate of the component. The most
reliable operation typically occurs a half inch or so away
from the IR sensor. Once you have found the spot that gives
the most reliable operation, peel off the protective backing of
the self-adhesive tape on the included flashers and stick them
in place.
Note:
Always replace the self-adhesive tabs if you have to
reposition a flasher. Six extra self-adhesive tabs are supplied
for this purpose.
Warranty
The MRF-100 is covered against any manufacturers defects or
workmanship for a period of one year from the date of pur-
chase if purchased from an authorized Universal Remote
Control dealer. Units purchased from online auction sites or
other unauthorized resellers have no warranty. This warranty
does not cover the following items:
-Damage from misuse, neglect, or acts of nature.
-Products that have been modified or incorporated into other
products.
-Products purchased more than 12 months ago.
-Units purchased from unauthorized dealers or companies.
Specifications
Power Supply: 9V 300mA
IR Flasher Line Outputs: 2.5mm Mono Mini Jack
RF Frequency: 418MHz
Содержание Expander MRF-100A
Страница 1: ...Owner s Manual...
