Universal Remote Control POWERBLASTER MRF100B, Руководство пользователя, Страница: 5 / 13

PowerBlaster
TM
P
A
R
TS GUIDE
7
PowerBlaster
TM
PROGRAMMING
8
Six plug-in flashers are supplied
with 10 foot cables and six extra
self-adhesive pads (in case a
flasher has to be repositioned).
Integrated antenna swings
in any direction to optimize
RF reception and range.
Six flasher jacks on the rear of PowerBlaster™ connect
flashers for control of A/V components out-of-sight of the
front blaster.
Included 9V power supply
plugs into the MRF-100
power connector.
Program and Test Remote Control First
Don’t connect power to PowerBlaster™ until you have pro-
grammed and tested the remote control line of sight.
PowerBlaster™ can interfere with testing and programming.
STEP 1:
Turn ON all of your components.
Audio /Video components some-
times create RF interference.
Therefore, perform all testing
with all of your components
powered ON (as they will be
when you operate the system).
SETP 2:
Connect the Power Supply.
Connect the 9V power supply to
an active UNSWITCHED AC
outlet. PowerBlaster™ must
always be powered up. The red
Power LED should light up.
STEP 3:
Test Placement of PowerBlaster™.
PowerBlaster™ should be
placed so that the STATUS LED
only lights up when a button is
pressed on an RF series remote
control. It should go out as soon
as the button is released. If
there is any flickering, move
PowerBlaster™ farther away
from the A/V components.
STEP 4:
Orient the Antenna for Optimum
Range.
If you need to extend the
range of the remote, try adjusting
the angle of PowerBlaster’s™
receiving antenna via it’s pivoting
ball mount.
STEP 5:
Mount PowerBlaster™.
PowerBlaster™ may be
concealed and mounted to the
rear wall or back of the system
cabinet. The mounting plate
slides apart from the receiver,
mounts to the wall, then the
receiver can slide back into
place.