Univers by FTE U4112, Руководство пользователя

Страница: 32 / 38

PAG . 32
rev 1.1
English
SYSTEM SETUP
the message “Saving Data, Please Wait…”. From now on you
need to use the new password to open locked menus or locked
channels.
NOTE: The default password is 0000
5. Press [Exit] to leave the “Parental Lock” menu.
5.6. LNB POWER
When you select this option, you will see a screen like beside
(OSD 72):
1. LNB Power: If your receiver is connected to the LNB directly
then you need to set the LNB Power to “On”. If your receiver is
connected to a multi switch (SMATV signal distribution system)
then it may be that you don’t need to provide the power to
the LNB. But since this is depending on the kind of installed
distribution system we recommend you to contact your installer
or to refer to the user manual of this system to get the correct
information.
You also just can change this setting and check if you still can
receive the channels. If the LNB Power is off and you still can
see all channels then we recommend this setting.
2. Low Power Consumption: At this option, you could enable
/ disable the low power consumption mode. This mode allows
saving current consumption when the receiver is stand-by.
Low power consumption mode only can be enabled when
the VCR Loopthrought option (see point 5.2.) is STB master
selected. By the other way, if you choose VCR master, then
the Low Power Consumption option will not be active and the
receiver will not be in LPC mode.
3. Press [Exit] button to leave this menu.
5.7. RCU POSITION SWITCH
In order to avoid interferences between remote controls, you
have the possibility to change the code of it, to do that you have
to change the position of a switch in the remote control.
But first of all you have to change this code in the receiver. You
can do this in the menu “RCU Position” (OSD 73).
You have to select the same position in the receiver than in the
remote control (OSD 74).
OSD 72
OSD 73
OSD 74