Unitronics Vision OPLC V130-33-B1, Руководство по установке

Страница: 7 / 7

Vision™ OPLC™
Opening the Controller
Before performing these actions, touch a grounded object to discharge any electrostatic
charge.
Avoid touching the PCB board directly. Hold the PCB board by its connectors.
1. Turn off the power supply, disconnect, and dismount the controller.
2. The back cover of the controller comprises 4 screws, located in the corners. Remove the screws,
and pull off the back cover.
Changing Communication Settings
1. To access the communication
jumpers, hold the Power Supply
PCB by its edges and steadily pull
the board off.
2. Locate the jumpers, and then
change the settings as required.
Jumper settings are shown on
page 6.
Closing the Controller
1. Gently replace the board. Make
certain that the pins fit correctly
into their matching receptacle.
Do not force the board into place;
doing so may damage the
controller.
2. Replace the back cover of the
controller and fasten the corner
screws.
Note: You must replace the back cover securely before powering up the controller.
Samara
tel. +7 846 273 95 85
samara@klinkmann.spb.ru
Yekaterinburg
tel. +7 343 287 19 19
yekaterinburg@klinkmann.spb.ru
St. Petersburg
tel. +7 812 327 3752
klinkmann@klinkmann.spb.ru
Moscow
tel. +7 495 641 1616
moscow@klinkmann.spb.ru
Helsinki
tel. +358 9 540 4940
automation@klinkmann.fi
Vilnius
tel. +370 5 215 1646
post@klinkmann.lt
Riga
tel. +371 6738 1617
klinkmann@klinkmann.lv
Мinsk
tel. +375 17 200 0876
minsk@klinkmann.com
Tallinn
tel. +372 668 4500
klinkmann.est@klinkmann.ee
Кiev
tel. +38 044 495 33 40
klinkmann@klinkmann.kiev.ua