Unitronics V570-57-T20B, Руководство по установке

Страница: 5 / 8

Installation Guide Vision™ OPLC™ V570-57-T20B, V570-57-T40B
Unitronics 5
Wiring
ƒ Do not touch live wires.
ƒ Unused pins should not be connected. Ignoring this directive may damage the device.
Caution
ƒ To avoid damaging the wire, do not exceed a maximum torque of 0.5 N·m (5 kgf·cm).
ƒ Do not use tin, solder, or any substance on stripped wire that might cause the wire
strand to break.
Use crimp terminals for wiring; use 26-14 AWG wire (0.13 mm
2
–3.31 mm
2
).
1. Strip the wire to a length of 7±0.5mm (0.250–0.300”).
2. Unscrew the terminal to its widest position before inserting a wire.
3. Insert the wire completely into the terminal to ensure a proper connection.
4. Tighten enough to keep the wire from pulling free.
Power Supply
The controller requires an external 24VDC power supply. The permissible input voltage range is
20.4-28.8VDC, with less than 10% ripple.
ƒ A non-isolated power supply can be used if a 0V signal is connected to the chassis.
ƒ Install an external circuit breaker. Guard against short-
circuiting in external wiring.
ƒ Double-check all wiring before turning on the power
supply.
ƒ Do not connect either the ‘Neutral or ‘Line’ signal of the
110/220VAC to device’s 0V pin.
ƒ
In the event of voltage fluctuations or non-conformity to
voltage power supply specifications, connect the device
to a regulated power supply.
Earthing the Power Supply
To maximize system performance, avoid electromagnetic interference by:
ƒ Mounting the controller on a metal panel.
ƒ Earthing the controller’s power supply: connect one end of a 14 AWG wire to the chassis
signal; connect the other end to the panel.
Note: If possible, the wire used to earth the power supply should not exceed 10 cm in length.
However, it is recommended to earth the controller in all cases.