Unitronics JZ20-J-T20HS, Руководство по установке

Страница: 1 / 6

Unitronics 1
Jazz
™PLC+HMI
Micro-PLC+HMI Installation Guide
JZ20-T10/JZ20-J-T10

6 Digital Inputs including 2 HSC, 4 Transistor Outputs
JZ20-T18/JZ20-J-T18 
6 Digital Inputs including 2 HSC, 2 Analog/Digital Inputs,
2 Analog Inputs, 8 Transistor Outputs
JZ20-J-T20HS

6 Digital Inputs including 3 HSC/Shaft-encoder,
2 Analog/Digital Inputs, 2 Analog Inputs,
10 Transistor Outputs

Before using this product, the user must read and understand this document.

For additional information regarding this product, refer to the user guide and technical specifications.

All examples and diagrams are intended to aid understanding, and do not guarantee operation.
Unitronics accepts no responsibility for actual use of this product based on these examples.

Please dispose of this product according to local and national standards and regulations.

Only qualified service personnel should open this device or carry out repairs.
Failure to comply with appropriate safety guidelines can cause severe injury or property
damage.

Do not attempt to use this device with parameters that exceed permissible levels.

To avoid damaging the system, do not connect/disconnect the device when power is on.
Environmental Considerations

Do not install in areas with: excessive or conductive dust, corrosive or flammable gas,
moisture or rain, excessive heat, regular impact shocks or excessive vibration.

Ventilation: 10mm space required between the PLC+HMI
s’ top/bottom edges & enclosure
walls.

Do not place in water or let water leak onto the unit.

Do not allow debris to fall inside the unit during installation.
Mounting
Dimensions
* Note that for JZ20-J modules those dimensions are 7.5 mm (0.295
”).