Revision date: 23/09/2014
Page 20 of 24
MOVING PARTS can cause injury
.
Keep away from moving parts such as fans. Keep all doors, panels, covers, and guards closed and
securely in place.
H.F. RADIATION can cause interference
.
High-frequency (H.F.) can interfere with radio navigation, safety services, computers, and
communications equipment. Have only qualified persons familiar with electronic equipment perform
this installation.
The user is responsible for having a qualified electrician promptly correct any interference problem
resulting from the installation.
If notified about interference, stop using the equipment at once. Have the installation regularly
checked and maintained. Keep high-frequency source doors and panels tightly shut, keep spark
gaps at correct setting, and use grounding and shielding to minimize the possibility of interference.
ARC WELDING can cause interference
.
Electromagnetic energy can interfere with sensitive electronic equipment such as computers and
computer-driven equipment such as robots.
Be sure all equipment in the welding area is electromagnetically compatible.
To reduce possible interference, keep weld cables as short as possible, close together, and down
low, such as on the floor.
Locate welding operation 100 meters from any sensitive electronic equipment.
Be sure this welding machine is installed and grounded according to this manual.
If interference still occurs, the user must take extra measures such as moving the welding machine,
using shielded cables, using line filters, or shielding the work area.
EMF Information
Considerations about welding and the effects of low frequency electric and magnetic fields.
Welding current, as it flows through welding cables, will cause electromagnetic fields.
There has been and still is some concern about such fields.
However, after examining more than 500 studies spanning 17 years of research, a special blue
ribbon committee of the National Research Council concluded that: “The body of evidence, in the
committee’s judgment, has not demonstrated that exposure to power-frequency electric and
magnetic fields is a human-
health hazard.”
However, studies are still going forth and evidence continues to be examined. Until the final
conclusions of the research are reached, you may wish to minimize your exposure to
electromagnetic fields when welding or cutting.
To reduce magnetic fields in the workplace, use the following procedures:
1. Keep cables close together by twisting or taping them.
2. Arrange cables to one side and away from the operator.
3. Do not coil or drape cables around your body.
4. Keep welding power source and cables as far away from operator as practical.
5. Connect work clamp to workpiece as close to the weld as possible.
About Pacemakers:
Pacemaker wearers consult your doctor first. If cleared by your doctor, then following the above
procedures is recommended.