Before first use
Unpacking:
This product has been packaged to protect it against
transportation damage. Unpack the appliance and keep the original
packaging carton and materials in a safe place. It will help prevent any
damage if the product needs to be transported in the future, and you can
use it to store the appliance when it is not in use. In the event it is to be
disposed of, please recycle all packaging materials where possible.
Safe packaging disposal:
Plastic wrapping can be a suffocation hazard
for babies and young children, so ensure all packaging materials are out of
their reach and disposed of safely.
Inspection:
Unwind the cord to its full length and inspect it for damage. Do
not use the appliance if the appliance or its cord have been damaged or
are not working properly.
In case of damage, contact our after sales
support line for advice on examination, repair or return of the
damaged product.
Assembly
Your new fan has been shipped partially assembled to reduce wastage of
packaging material, paper cartons and weight. Follow the drawing above to
assemble it; the illustration opposite shows how all the parts fit together.
1. Take out the base screw and nut ( 18 and 22 ) from the small plastic
bag to connect column ( 17 ) , base( 20 ) and base weight ( 21 ) together
and tighten screws .
2. Loosen the column nut (16) at the top of the column and pull out the
extension pole to the desired height, or all the way to the top for maximum
height (you may have to push it up from the bottom if it is tight or stuck). At
the desired height, turn the column nut clockwise to tighten securely.
3. Lightly loosen the hand for column (15), attach the fan body to the top
of the extension column. Push the body down as far as possible and then
tighten securely with the set screw.
4. Unscrew guard lock (8) and remove it from the motor shaft.
5. Position the rear guard (9) through the motor shaft against the motor
housing, placing the vertical holes in the guard over the two pins on the
housing. Make sure the handle is on top. Screw on the guard lock in
clockwise direction to hold the rear guard securely in place.
6. Place the blade(7) on the motor shaft. Secure the blade with the blade
lock(6), turning it anticlockwise to tighten.
7. Assemble the logo ring (1) on front guard (2) , then assemble front
guard and rear guard together by tighten the guard nut . Finally assemble
the safe screw and nut ( 3 and 4 ) at the bottom of guard.
