UNITED UHR-873, Инструкция по эксплуатации

Страница: 5 / 9

Clock setting
The timer, as all clocks, must be set to the current time. For example, if
it is 9 a.m., turn the dial clockwise (in arrow direction) until 9 is aligned
with the triangular pointer (Fig.3).
Timer setting
Triangular Pointer
Segments
• There are
96 segments around the circumference, each segment
being equivalent to 15 minutes of time. With this timer you can preset
the time and duration of the periods that it is desired to operate the
heater, in any 24hr period.
With the timer you can set your setting to
within 15 minutes and program up to 48 cycles (1 cycle = 1 “ON” + 1
“OFF”) over a period of 24 hours.
•
Using your fingers, push the segments inwards or pull them
outwards.
*
When the segment is in the outward position (towards the numbers
of the dial), the heater will operate during that 15 minute period.
*
If the segment is in the inward position, the heater will not operate
during this period.
IMPORTANT!
•
Do not turn the timer dial anticlockwise. Always turn in clockwise
direction.
•
The timer is in effect an electric clock and only works when the plug is
connected to the power supply. Whenever the plug is disconnected,
the timer stops and must be reset.
Fig.3