●
periodically clean the exterior and rear cylinder, storage area of your
heater to remove dust an lint built-up, which may affect operation of the
heater.
●
light vacuuming with a soft brush will remove any dust built-up on the
surfaces of the ceramic elements. do not scrape of knock these elements
as they may become very fragile with use.
●
do not abrasive products to clean the heater.
●
watch the pilot flame while it is in operation. it should burn steadily,
if it flickers or is yellow tipped, the heater should be checked for correct
operation.
●
if any parts need replacement, they must be replaced only with genuine
original parts supplied by the manufacturer. the use of incorrect or
substitute the parts may be dangerous and will void any warranty.
Operate the heater according to following procedures when electric power is used.
The electric heating system is designed with technology of infrared radiation. Even if it
is used in an unsealed and large size room, heating efficiency will be perfect. Choose
1) Operation
a. Make sure plug is normally earthed. Put plug in the socket.
b. Press switch - to start the top quartz tube.
c.Press switch = to start the other two quartz tubes.
d. Press switch - and = to start all quartz tubes.Heat load reachs to peak.
e. Turn all switch off after use. Remove the plug from the socket.
As shown in below Figure.
