Setting the Timer
Ensure the slide switch on the timer is at the mid position next to the clock symbol.
Rotate the outer ring of the timer in a clockwise direction until the current time is lined up with the
arrow pointer, i.e. if the time the timer is being set is 8 p.m., rotate the outer ring forward appropriate
to the running period(s) required.
When set, the heater will operate each day during the time period it has been programmed. Note, the
heater must always be plugged into a power socket, the switches must be set in the “on” position and
the thermostat must be properly set to ensure the heater will come on.
If the heater is required to run continuously the slide switch on the timer should be set to the “I”
position.
If it is subsequently required to revert back to timer operation, the slide switch on the timer should
be set to the central(clock) position.
Note: When using in timer mode, due consideration should be given to the fact that the heater may
come on whilst unattended.
REGULATING THE THERMOSTAT
When the room has reached the requi
r
ed temperature turn the right thermostat knob (where
included) in an anti- clockwise direction up to the point where the appliance switches off and not
beyond that point. The temperature fixed in this way will be automatically regulated and kept at a
constant level by the thermostat.
CLEANING AND MAINTENANCE
Before cleaning always remove the plug from the electrical socket.
Clean the air inlet / outlet grilles frequently.
Never use abrasive powders or solvents.
WARNINGS.
-
Do not use the appliance in the vicinity of showers, bath tubs, wash basins, swimming pools, etc.
-
Always use the heater in an upright position
-
Do not use the heater to dry your laundry, Never obstruct the intake and outlet grilles (danger of
overheating).
-
The heater must be positioned at least 50 cm from furniture or other objects.
-
When the appliance is used as a portable device, do not place it up against walls, furniture,
furniture, curtains, etc.
-
The appliance must be installed so that the switches and other controls can not be reached by
persons using the bath tub or the shower.
-
This appliance comes with a type Y attachment. Replacement of the feed cable must be
entrusted only a technician authorized by the manufacturer, because such work requires special
tools.
-
The appliance must not be positioned directly below a fixed power point.
-
Do not use the appliance in rooms less than 4m
2
area
-
Do drop the heater from any height.
-
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety. children should be supervised to ensure that they do not play with the appliance.
The heater is fitted with a thermal cut-out which will switch off the heater in case of accidental
overheating (e.g. obstruction of air intake and outlet grilles, motor turning slowly or not at all). If such
condition occurred, disconnect the plug from the power for a few minutes, remove the cause of
overheating then plug the appliance in again.
The heater is also fitted with a thermal link which will switch off the heater in case overheating while
the thermal cut-out is inoperable. If such condition occurred, the appliance could not be used again
before being checked and repaired from authorized technician.
